200-301 download warez

200-301 download warez.any problems, and list the interface-related problems that need to be checked further based on this output.Example 3-8 Interface Problems with SW1 and SW3SW1# show interfaces Name Port FaO/11 SW1# show interfaces Port Name FaO/12 SW1# show interfaces Port Name GiO/1 SW1# show interfaces Port Name GiO/2 faO/ 11 status Status connectedVian 3 faO/12 status Status Vian notconnect 3 GiO/1 status Status Vian connected trunk GIO/2 status Status Vian connected trunk Duplex Speed Type a-full a-100 10/100BaseTX DuplexSpeed Type auto auto 10/100BaseTX DuplexSpeed Type a-fulla-1000 lO/lOO/lOOOBaseTX DuplexSpeed Type a-full a-1000 lO/lOO/lOOOBaseTX! Switching to SW3 next SW3# show interfaces Port Name FaO/13 SW3# show interfaces Port Name GiO/1 SW3# show interfaces Port Name GiO/2 faO/13 status Status Vian connected 3 GiO/1 status Status Vian connected trunk GiO/2 status Status Vian connected trunk DuplexSpeed Type a-halfa-100 10/100BaseTX DuplexSpeed Type a-fulla-1000 lOOOBaseTX DuplexSpeed Type a-fulla-1000 lOOOBaseTXThere is apparently a problem on SW1, where interface FaO/12 is in a no-connect state. There are many reasons for this condition to occur, most of which are related to cable problems-conditions such as a cable not being fully inserted into a switch port can cause hard-to-detect interference faults (see the causes listed in Table 3-2).SW3's interfaces do not appear to have any problems on the surface. However, all three interfaces on this switch use the same duplex settings due to a failed autonegotiation process, and it is particularly noteworthy that FaO/13 uses half duplex. This can result in a duplex mismatch.You can ensure that the GiO/1 and Gi0//2 interfaces of SW3 do not have mismatch problems by using the showinterfeces status command on SW1 and SW2 at the other end of the link, respectively. However, if it is the port connected to the PC that has failed and the administrator may not be at the PC, then the administrator can only be trying to guide the end user step-by-step to verify the rate and duplex settings. Even so, it is helpful to look at minimum-length messages (runt), conflicts (collision), and delayed conflicts (latecollision), as shown in the output of the show interfaces command in Example 3-9.3.2 Basics 71Example 3-9 Signs of Duplex MismatchSW3# show interfaces faO/13